Advertisement
2. Position the SIMM by the socket with the SIMM
tilted slightly towards the rear of the system unit.
3. Lower the SIMM into the socket, and ensure that the
SIMM is properly located in the connector.
4. Pushing gently on the top corners rotate the SIMM
backwards until it clips into place. Do not use
excessive force.
If the SIMM will not rotate easily remove it and start
again.
5. If the SIMM is properly located the SIMM should
remain in position held by the securing clips, and
with a small plastic lug through the holes on either
side of the SIMM.
11
Advertisement
