Assembly; Operation - Husqvarna DM700 Operator's Manual

• Do the maintenance to make sure that the product
operates correctly. Refer to
on page 12 .
Introduction
WARNING: Read and understand the safety
chapter before you assemble the product.
WARNING: To prevent injury, disconnect the
power cord and remove the drill bit before

assembly.

To attach the product to a drill stand
CAUTION: Read the operator's manual for
the drill stand carefully.
• To attach the product to a drill stand, refer to the
manual for the drill stand.
• Use only with approved Husqvarna drill stands.
Applicable drill stands on page 16 .
Refer to
To install a drill bit
1. Install the supplied friction ring to the spindle shaft.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Read the operator's manual for the drill stand
carefully and make sure that you understand the
instructions.
3. Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
4. Do the daily maintenance. Refer to
schedule on page 12 .
8
Maintenance schedule
Assembly

Operation

Maintenance
• Do not use a product that is defective.
Note: The friction ring prevents damage to the
spindle shaft and the gearbox during removal of the
drill bit.
2. Turn the drill bit counterclockwise to install it. Tighten
fully.
5. Make sure that only approved persons are in the
work area.
6. Make sure that the product is assembled correctly
and not damaged. The drill bit and the drill stand
must be attached correctly.
7. Make sure that the water system is not damaged
and that it is connected to the product.
1320 - 001 - 14.10.2019