Operating Peripheral Equipment Using The Remote Control - Panasonic PT-52DL10 Operating Instructions Manual

Operating peripheral equipment using the remote control

Programming The Illuminated Remote Control Using Access Codes
The remote control can be preset for other manufactures, by utilizing the REMOTE MODE SELECTION BUTTONS for
CABLE, DTV, VCR, RCVR (a Receiver or Amplifier), DVD (DVD, CD, LD) ,DBS and AUX (for Cassette Player or a
VCR2.)
(Details on remote control buttons to operate peripheral equipment
LIGHT
POWER
ASPECT
MUTE TV/VIDEO
CH
ACTION
VOL VOL
MENU INFO/RECALL
CH
AV-ADJ NORMAL GAME RH-SPLIT
EXIT VCR REC GUIDE
SEARCH SPLIT
REW PLAY
STOP FF
FREEZE SWAP
TV/VCR VCR/DBS CHANNEL PAUSE
OPEN/CLOSE SLOW STILL
1 2 3
4 5 6
7 8 9
R-TUNE PROG
0
Note:
If an incorrect number is entered (or there is an incomplete entry after 28 seconds), the key illumination goes out (no
blink) and setting are unchanged.
1 Setting up the remote using the numerical keys.
(When code known):
1
POWER
+
CH
ACTION
VOL
CH
2
3
1 2
4 5
7 8
0
Device
TV TV (Only Panasonic)
VCR VCR (Preset)
CBL Cable Boxes (Preset)
DBS DBS Boxes (Preset)
RCVR RCVR (Preset)
AUX Cassette Players, V CR2 (Preset)
DVD DVD & LD & CD Player (Preset)
DTV STB (Only Panasonic)
See page 65 to 67 and 68 to 70)
Press and hold the POWER and ACTION keys
simultaneously for three full seconds.
After 3 seconds, all the illuminated mode keys
will begin to flash. Then let go of the POWER
and ACTION keys.
VOL
Press the desired mode key.
The mode key will illuminate steadily , all others
will go out.
3
Enter the three digit set up code, by using the
Remote Control Keyboard.
6
If the correct code is entered, the mode key
will blink twice and then go out.
9
Now your remote is set for this code.
Operate Default
Panasonic Code
Panasonic Code
Panasonic Code
Panasonic Code
Technics Code
Technics Cassette Players Code
Panasonic DVD Code
Panasonic Code
63