Panasonic EP1082KL-COMBO Operating Instructions Manual page 9

3 HOW TO MOVE THE UNIT
Using the wheels to move the unit
• Hold the backrest to move the unit when using the wheels.
• It is easier to move the unit with the massage heads
retracted and the backrest in the upright position.
* Place a mat or cloth on the floor and move the unit slowly
to prevent floor damage.
Move it slowly
Wheels
4 INSTALL THE ARMRESTS ON THE UNIT
Left
Front
Velcro
Convex
Front
Allen key
Back
Zipper
Round hole
Rear
Lift up
Secure with screws
Lifting the Unit
• Move the unit by having  persons hold the armrests.
* Please hold the armrests securely to avoid dropping the
unit as it may damage your floor.
1
Install the armrests.
1 Unfasten the velcro.
2 Unzip the zipper of the armrest completely.
3 Make sure to confirm the side (left or right) and
direction (front or back) for each armrest.
The illustration shows the left armrest. The right armrest
is stamped "Front", "Right" and "Back".
* The left armrest must be installed on the left hand side of
the unit.
4 Align the proper armrest with the unit and connect.
Be careful not to catch the fabric between the chair
and the armrest.
2 Secure the armrests with attachment
screws.
(Total of 4 positions for a single armrest)
Lift the fabric on the side of the armrest and insert the
attachment screw onto the end of the Allen key, and
then tighten.
(Tighten the screws in the 4 positions lightly at first, and
then tighten all screws firmly.)
* If the screw does not enter into the hole, tighten the screw
by pushing the armrest from the top.
3 Close the zipper at the bottom side of
the armrests.
When closing the zipper, be careful not to twist the end of
the zipper.
1 Set the velcro.
2 Zip the zipper.
4 Put both ends of the zipper into the
inside.
1 Turn in the edge of the zipper.
2 Fix the sliding tab of the zipper with the velcro.
8