Factory Defaults; Re-Map Pelco Aux (Pelco D And P Protocols Only) - Bosch MIC SERIES 500 CAMERA 500 User Manual

MIC Series 500 Camera
Menu Item Description
CLEAR SOFT Clears any Soft stops that have been applied.
STOPS
MANUAL Gives the user 10 seconds of manual control of the camera to allow the operator to move the
CONTROL camera to the desired position before the menu returns to its previous state.
WASH WIPE Sets the wash position by pointing the camera at the washer nozzle
POSITION and pressing right to set.
SET ZERO Sets the zero degree (North) position when using the compass
POS direction captions. For example, point the camera North, Set Zero Pos,
resulting in the caption correctly displaying the compass heading.
UPPER LEFT Soft Stops enable the user to set up an imaginary box within which the
AND LOWER camera can move. There is only one zone available which is defined by
RIGHT SOFT first setting the Top Left and then the Bottom Right of the zone. Once
STOP activated the MIC cannot be moved beyond the area set.
LEFT AND These 2 settings define the limits within which the camera will pan at
RIGHT AUTO the "Auto Pan Speed" when the "Auto Pan" feature is activated.
PAN LIMITS
MAP AUX TO This option opens a submenu that allows certain features of the
PRESET camera which would normally be controlled through Aux commands to
be mapped to Go To Preset commands. The features available for this
are Wiper, Washer, Digital Zoom, Auto Iris, Auto Focus, and Auto Pan.
For each function there are 3 options: Control, On Preset, and Off
Preset. The control field denotes if the function is activated by the
normal aux command or through a preset. The other 2 options set the
preset number to activate or deactivate each function. This provides
the ability to run all of the camera's standard auxiliaries from a wider
range of control systems with varying direct aux support.
Note: If the control field of any of the functions is set to Go To Preset,
then the feature will not work using a standard button from a normal
controller. Similarly, if mapped to an Aux command, the preset values
indicated will have no effect.
FIND END Rotates the tilt axis first down then up to its mechanical limit stops. It
STOPS then stores a "soft" limit a few units back from these for normal use.
Note: manual control is not available during this process.
RESET TO Resets to the default settings for all OSD menus.
DEFAULTS
5.7.1

Factory Defaults

Restores the camera unit to the Factory Default settings. See Section 5.14.1 Factory Defaults,
page 49.
5.7.2

Re-map Pelco Aux (Pelco D and P Protocols only)

The Pelco protocols (D and P) support 8 different auxiliaries, but do not define what function
each should perform. This feature enables the 8 available auxiliaries to be set to any of the 8
available functions (Auto Focus, Digital Zoom, Auto Iris, Wiper, Washer, OSD and Backlight).
By default, the auxiliaries are mapped as follows:
Bosch Security Systems, Inc. User's Manual
Navigating the Menus | en
Options Default
RIGHT TO N/A
CLEAR
RIGHT TO SET current
POS camera
position
RIGHT TO SET N/A
POS
RIGHT TO SET Cleared
POS
RIGHT TO SET Cleared
POS
WIPER, N/A
WASHER,
DIGITAL
ZOOM,
AUTO IRIS,
AUTO FOCUS,
AUTO PAN
RIGHT TO N/A
START
CONFIRM N/A
RESET, NO
F.01U.173.601 | 2.0 | 2010.11
33