Switching On The Fan; Set Heating Time; Overheating Protection - Silvercrest SKD 2300 D4 Operating Instructions Manual

Switching on the fan

The appliance has a fan which can be used to distribute heated air throughout the
room more quickly.
♦ Press the fan button
If the fan is running, the „Fan" symbol
NOTE
► If the fan is switched off, the heat is concentrated more around the appliance
and is not distributed so quickly around the room.

Set heating time

The appliance has a timer that you can use to set the desired heating time between 1 to
24 hours. Once this period is over, the appliance switches off automatically.
♦ Press the timer button
2
display
♦ To switch the timer off, press the timer button
18
runtime

Overheating protection

The appliance is fitted with a thermostat-controlled overheating protector. If the appli-
ance becomes too hot internally, the heating element switches off automatically. As
soon as the appliance has cooled down, the heating element switches back on.
WARNING
As a general rule, there is a reason for overheating! It can mean a
risk of fire!
► Check that the appliance can sufficiently dissipate the heat generated: Is the
appliance covered or is it too close to a wall or other obstacle? Is the fan
blocked?
► Check that neither the air inlet
the cause.
► If possible, eliminate the problem or contact the Service Hotline (see the chap-
ter Service).
► Even if you cannot find a cause, but the overheating protection triggers a
second time, you must return the appliance to Customer Services for inspection
or repair.
│ GB │ IE
■ 32
14
27
or
17
or
.
appears on the display
5
to switch the fan on or off.
11
appears on the display
until the desired runtime
17
or
2
.
3
nor the air outlet
2
.
18
is shown on the
repeatedly until no
is blocked and remove
SKD 2300 D4