Specifications - Sanyo MCO-18AC UV Instruction Manual

SPECIFICATIONS

Name
Model
External dimensions
Internal dimensions
Interior volume
Exterior
Interior
Outer door
Inner door
Tray
Access port
Insulation
Heating system
Heater
Humidifying system
Temperature controller
Temperature display
CO controller
2
CO density display
2
Air circulation
Air filter
UV lamp
Water level sensor
Alarm
Remote alarm contact
CO inlet connection
2
CO inlet pressure
2
Accessories
Weight
Optional accessory
Note: Design or specifications will be subject to change without notice.
MCO-18AC
3 trays made of stainless steel containing copper
W450 x D450 x H12 (mm), Maximum load; 7 kg/tray
Inner diameter; 30 mm, On the back side
Rigid polyurethane foamed-in place
DHA system (heater jacket + air jacket system)
Natural evaporation with humidifying pan
ON-OFF control system/TC sensor
0.3μm, Efficiency; 99.97% or more
-----
-----
-----
Automatic set temperature alarm, Automatic set CO
Upper limit temperature alarm, various gas/sensor/heater alarms
Allowable contact capacity: DC 30 V, 2 A
4 to 6 mm diameter tube can be connected
0.03MPaG (0.3kgf/cm
3 trays, 3 sets of tray support, 1 gas tube, 1 humidifying pan,
Stacking plate A and B, 2 protective stickers, 2 tube bands
92 kg
UV system kit (MCO-18UVS3)
UV replacement kit (MCO-20UV), 4-20mA Interface(MCO-420MA, USA only)
Gas pressure regulator (MCO-100L)
Extra tray (MCO-47ST) including 2 tray supports, Half tray (MCO-25ST)
Automatic CO cylinder changeover system (MCO-21GC), Roller base (MCO-18RB)
2
RS232C/RS485 Interface (MTR-480), Ethernet (LAN) Interface (MTR-L03)
SANYO Data acquisition software (MTR-5000)
CO incubator
2
W620 x D710 x H900 (mm)
W490 x D523x H665 (mm)
170 L
Painted steel
Stainless steel containing copper
Painted steel
Tempered glass
282 W
PID control system
Digital display
Digital display
Fan assisted
4W X 1 (ozone-free emission)
Low humidifying water alarm
2
G, 4.3psiG)
42
MCO-18AC(UV)
Optical type
UV lamp failure alarm
density alarm
2
93 kg
Standard equipment