Advertisement
Available languages
Available languages
Software Preparation
Windows 98
Confirm the following contents in [Start] - [Settings] - [Control Panel] - [System] - [Device
Manager] - [CDROM] - [MATSHITA UJDA**** ] - [Properties] - [Settings]. Make the
settings if they have not yet been made.
Add a check mark for [DMA].
Set both [Start drive letter] and [End drive letter] in [Reserved drive letters] to [L:].
Windows 2000
Confirm that [Transfer Mode] is set to [DMA if available] in [Start] - [Settings] - [Control
Panel] - [System] - [Hardware] - [Device Manager] - [IDE ATA/ATAPI controllers] - [Sec-
ondary IDE Channel] - [Advanced Settings] - [Device 0]. Perform this setting if it has not
yet been made.
E
Using the CD-R/RW Drive Pack in the MS-DOS Mode
Windows 98
To use the CD-R/RW Drive Pack in the MS-DOS mode*, configure the drive following the
steps below after performing the above preparations. If the steps listed below are performed
without completing above preparations first, the drive will not operate properly.
*
In the MS-DOS mode, only CD-ROM discs are readable.
1
Select [Start], then select [Shut Down].
2
Select [Restart in MS-DOS mode], then click [OK].
3
Open the "CONFIG.SYS" file for editing by issuing the following commands:
cd \ Enter
edit config.sys Enter
4
Move the cursor to the line containing "OAKCDROM.SYS" and delete the characters
"rem" at the beginning of the line. (Deleting "rem" causes the item to become valid.)
DEVICEHIGH=C:\WINDOWS\COMMAND\OAKCDROM.SYS /D:MSCD000
(If this line is missing, add it.)
5
Press Alt + F , then S to save the file. Then press
exit the Edit program.
6
Follow the same steps to edit the "AUTOEXEC.BAT" file.
edit autoexec.bat Enter
6
(first time only)
Alt + F , then X to
Advertisement
