Advertisement
To control lights with the
SMRT
.com website,
SCAPE
you must first add LPCUs
to the SMRT
website,
SCAPE
similar to how you added the
irrigation controller.
Add an LPCU
1. Plug a LPCU into an
outlet.
2. On the SMRT
.com
SCAPE
website / app, click the
Lights tab and click Activate Discovery Mode
button.
Controller PIN Setup
The SMRT Logic PIN must match the PIN entered in
the EVOLUTION controller or Climate Logic device for
the system to operate.
Use the included SMRT Logic Information Card to
record the necessary info from the SMRT Logic device
and the irrigation controller for easy entry into the
SMRT
.com website.
SCAPE
To setup a new PIN or view an existing one, follow
these steps at the irrigation controller:
For an EVOLUTION controller:
Go to ADVANCED►ADD/REMOVE
DEVICE►REMOTE.
12
3. Discovery Mode is activated with a countdown
timer. Now, press the button on the LPCU.
4. LPCU should be quickly detected. Assign the
LPCU to a Scene and edit the Description field
as desired.
5. Click the Add LPCU button. You will receive a
confirmation message that the LPCU was added
to the scene.
Edit an LPCU
LPCU / EVO-AR
Click the pencil icon by the LCPU to edit.
Change the Scene and Description fields as
desired. Click Submit when done.
For a Climate Logic controller:
Go to MENU►REMOTE.
For a Climate Logic Mini Receiver (CL-MR):
1. Put the Mini Receiver into Learn Mode by
2. Enter the PIN under the corresponding
3. Manually turn a station ON or OFF.
4. The Mini Receiver will learn the new PIN
Delete an LPCU
1.
Click the trash can icon by the LCPU to
delete.
Click Yes at the confirmation prompt.
2.
holding down its button for more than 8
seconds.
SMRT
controller page.
SCAPE
and exit Learn Mode.
The PIN can be set in the CL-MR using a
remote transmitter (CL-R1). See the CL-MR
manual for instructions.
Advertisement
