Siemens xTronic HG241 5UC Instructions Manual page 4

1. CAUTION: Turn off Gas and Electricity
Before proceeding with the conversion; shut off the gas
supply to the appliance prior to disconnecting the
electrical power.
Shut off the outside propane tank gas valve to the range.
Remove range power cord from electrical outlet or turn
breaker off at breaker box, and turn all control knobs to
the "OFF" position.
2. Convert Pressure Regulator from 5" W.C.
to 10" W.C.
1. Remove Warming Drawer; Pull drawer out until stop
is reached. Facing the range, push clip on left side
up and clip on right side down. Pull drawer the rest
of the way out.
2. Remove cover plate from interior back wall by
removing single screw on left side of panel. Use a
torx T-20 head screwdriver.
3. Remove the hexagon cap from the top of the
regulator with an adjustable wrench.
4. Pop out the plastic stem in the cap and turn it over
pressing it firmly in place so that the letters "LP"
(rather than "NAT") are seen upright in the stem .
5. Replace the cap and button assembly into the top of
the regulator sealing it firmly. Make certain spring is
still in place (See Fig. 1). DO NOT OVER TIGHTEN.
6. Fill out and affix the CONVERSION STICKER on the
back side of the cover plate so that it appears on
the back side of range next to the regulator.
3. Replace Main Cooktop Orifices
Remove Grates, Burner Caps and Burner Bases. Unscrew
two (2) T20 screws inside each base and remove burner
bases (See Figure 2). Reinsert screws in jet holder to hold
tubing assembly in place.
Remove Natural Gas Cooktop Orifices. Insert the socket
driver with 3" minimum extension into the jet holders to
remove existing orifices. Place the old orifices in the
space provided on page 6 in case future conversion back
to natural gas is necessary.
Assemble LP Cooktop Orifices. Place in cooktop exactly as
laid out on the inside of the front cover of this manual
(also shown in Figure 3). If the orifices become
separated from the cover, placement can be determined
by matching the number and/or color on the orifice with
the placement specifications displayed in Figure 3.
Place the new orifice into the socket then insert each
orifice into its respective threaded hole in the jet holder.
Tighten until the orifice stops turning. DO NOT OVER
TIGHTEN.
Remove screws to replace burner base, burner cap and
burner grate. Replace screws.
Note: Burner cap must be properly positioned on burner
base for burner to light.
Conversion Instructions - Before you begin
Pin Position
for Propane
Pin Position
for Natural Gas
Hex
Cap
Pin
NA
T
NAT
PRESSURE REGULATOR VIEW
Figure 1 - Convert Pressure Regulator
Grate
Burner Cap
Burner Base
Orifice
Figure 2 - Remove Grate, Cap and Base
Left Rear Burner -
11,000 BTU/h 101 (Red)
BACK OF RANGE
FRONT OF RANGE
Left Front Burner -
7,500 BTU/h 86
(Yellow)
Figure 3 - LP Cooktop Orifice Placement
Hex
Cap
LP
LP
Spring
Ignitor
Right Rear Burner -
5,000 BTU/h 70
(Green)
Right Front Burner -
15,000 BTU/h 116
(White)