Advertisement
3.4 Attaching the RFID R/W Module
1. Fit the Cord Bush into the round hole on the Main Frame.
(When viewed from the front side)
2. Pass the Antenna Cable through the Cord Bush.
Antenna Cable
3. Pull out the Antenna Cable from the opposite side and pass it through the inside of
the Cable Guard.
Main Frame
Cord Bush
Cord Bush
Cable Guard
Antenna Cable
9/15
4. Secure two R/W Module Attachment Plates with one screw (PT-3x6) respectively.
5. Connect the Interface Cable to the RFID R/W Module and install it in the attachment plate
with three screws (PT-3x6).
Interface Cable
10/15
Screw (PT-3x6)
R/W Module Attachment Plate
Screw (PT-3x6)
R/W Module Attachment Plate
Screw (PT-3x6)
RFID R/W Module
Screw (PT-3x6)
Advertisement
