Advertisement
6. Insert the Antenna Cable into the connector of the RFID R/W Module.
RFID R/W Module
7. Insert the other side of the connector of the Interface Cable into the J1 Connector of
the Main PCB.
J1 Connector
Main PCB
8. By paying attention so as not to catch the cables, attach the Front Panel and the Side
Cover (L) in the reverse procedure of the removal.
Side Cover (L)
Front Panel
9. The installation of the RFID kit in the printer is now completed. Perform various
settings related to the RFID in the System Mode of the printer.
11/15
Antenna Cable
Interface Cable
RFID R/W Module
RFID MODULE SETTINGS
4.
After installing the RFID Module in the printer, set various settings related to the RFID in the
System Mode of the printer.
How to enter the System Mode
■
Power OFF
Turn on the printer while holding
down [FEED] & [PAUSE] or
[MODE].
SYSTEM MODE
<1>DIAG.
Press [DOWN]
<2>PARAMETER SET
until "<10>RFID"
<3>ADJUST SET
is highlighted.
<4>TEST PRINT
Contents of the RFID Menu
■
Menu
Sub menu
Parameter
RFID
TEST
ID READ
MODULE
MODULE TYPE
COUNTRY
TAG
RF CHANNEL
RETRY
ADJ RETRY POSITION
ISSUE RETRY LABELS
READ RETRY
WRITE RETRY
UHF SETTING
POWER LEVEL
Q VALUE
AGC THRESHOLD
WRITE AGC THRESHOLD
WRITE RETRY MIN AGC
OTHER
TAG CHECK
MULTI WRITE
CARRIER SENSE
Key functions in the system mode
■
Key
Function
[MODE]
Returns to the mode menu screen.
[CANCEL] or
Returns to the upper hierarchy.
[FEED]+[RESTART]
[ENTER] or [PAUSE]
Displays a next screen.
Saves the setting and returns to the upper hierarchy.
[UP] or [RESTART]
Moves the cursor upward.
Increases a value.
[DOWN] or [FEED]
Moves the cursor downward.
Decreases a value.
[LEFT]
Moves the cursor to the left.
[RIGHT]
Moves the cursor to the right.
SYSTEM MODE
<7>INTERFACE
<8>BASIC
Press [ENTER].
<9>FOR FACTORY
<10>RFID
These items cannot be set in this kit.
12/15
Advertisement
