Led Module - Fujitsu 8FX MB2146-510-01-E Setup Manual

3.4.5 A/D Module
VR1 and VR3 are to demonstrate a MCU A/D converter usage. Select VR1 or VR3 by the following
table.
VR1 is connected to MCU A/D channel 1, and VR3 is connected to MCU A/D channel 0.
A/D:
VR1
A/D:
VR3

3.4.6 LED Module

There are four LEDs on EV-board to demonstrate the I/O function.
Enable LED2, LED3 and LED4 in the following table,
LED*:
LED2, LED3, LED4
* : LED module has four LEDs in total, but P12 (LED1) is not active in a debug mode using
MCU Mode
Modules
BGMA.
Table 5 SW2 A/D Setting
Header name
SW2: VR1
LED3
SW2: VR3
LED3
Table 6 SW2 LED Setting
Header name
SW2:
LED2, LED3
LED3
SW1: LED4
Settings
SW2
VR3 VR1 SCK SOT SIN
ADC LIN UART
SW2
VR3 VR1 SCK SOT SIN
ADC LIN UART
Settings
SW2
VR3 VR1 SCK SOT SIN
ADC LIN UART
SW1
LED4 BUZ
LED2 S2 S1
KEY
LED2 S2 S1
KEY
LED2 S2 S1
KEY
13