Step 2: Connect A Computer To A Volume - Dell EqualLogic PS Series Installation And Setup Manual

Installation and Setup
Figure 4-4: Create Volume – Summary

Step 2: Connect a Computer to a Volume

When you create a volume, the PS Series group automatically generates an iSCSI
target name, with the volume name appended to the end of the target name. Each
volume appears on the network as an iSCSI target.
An example of an iSCSI target name for a volume named
iqn.2001-05.com.equallogic.5-4a0900-2f00000-007eca92d654f160-dbvol
To connect a computer to a volume:
1. Install and configure an iSCSI initiator on the computer. Hardware and
software initiators are available from different vendors. Configure your
initiator using the instructions provided by the vendor.
Note: Dell recommends that you visit the Technical Support website to
obtain important information about using initiators to access PS Series
group volumes.
2. Make sure that the computer matches one of the volume's access control
records. To display the records for a volume:
Storage Allocation
is as follows:
dbvol
4–5