Silvercrest WK 8 A2 Quick Start Manual page 36

The selected number combination must now be entered every time
the camera is switched on before it can be operated.
If you enter the incorrect password five times in a row, the camera
will switch off. Switch the camera back on again for another five
attempts at entering the password.
If you forget the number combination, proceed as follows to unlock
the camera and to reset it to its factory default settings:
♦ Download the game camera software from the product support
page on www.kompernass.com.
♦ Unzip the file and copy the files "ISP_SD.bin" and
"Rom_CodeWK8A2.bin" onto a blank memory card.
♦ Insert the memory card into the device while the mode selector
13
switch is set to the OFF position.
♦ Keep the
switch to the TEST position. Keep the
until the display
Keep table".
♦ After around 20 seconds the camera switches off.
♦ Switch the camera back on by moving the mode selector switch
to the OFF position and then to the TEST position. The camera
can now be used without entering a password.
NOTICE
► This procedure will permanently delete any previously made
settings and return the device to the factory settings.
Beep sound
The device allows you to select whether or not you wish to hear an
audible signal (default setting) when you press a button.
│ GB │ IE │ NI
■ 26
button pressed while moving the mode selector
10
shows the notification "Firmware upgrading...
button pressed down
WK 8 A2