Download Print this page

Troubleshooting; Transportation, Storage And Disposal - Husqvarna S 13 Operator's Manual

Hide thumbs Also See for S 13:

Advertisement

Note: Recommended intervals for filter change: Pre-filter
every 6 months and HEPA filters every 12 months.
1. Loosen the screws on the filter cover cap.
2. Carefully lift the filter into a clean plastic bag, this
bag must be properly disposed.
3. Insert a new filter in reverse order.
To change the pre-filter
CAUTION: When you remove the pre-filter in
order to clean it, use only low pressure water
Troubleshooting schedule
Issue
Motor does not start
Motor stops immediately after
starting
Motor runs but there is not
suction
Motor runs but there is poor
suction
Dust blown from motor
Abnormal noise
Transportation of the product
Make sure that the Longopac bag is empty before a
transportation
20

Troubleshooting

Cause
No power
Cable defective
Switch defective
Soft start defective
Wrong fuse
Shortcut in cable/machine
Hose not connected
Hose blocked
No dust collection bag
Hole in hose
Filter clogged
Loose top cover
Dirt in the flap
Defective gaskets
Wrongly assembled or damaged filter system

Transportation, storage and disposal

from the inside through to the out. Hitting the
filter with force, high pressure water or use
of compressed air will destroy the filter. The
filter must be 100% dry before returning into
the housing.
1. Loosen the 3 toggle fastners and remove the top.
2. Take the bag from the new filter.
3. Lift out the filter and place it gently in a plastic bag.
This bag must be properly disposed.
4. Insert a new filter.
Make sure that the Longopac bag is attached to the
product during transportation.
Use ramps or winches to lift the dust extractor to
make sure that movements are safe. Get aid if you
are not sure about how to lift heavy equipment.
Solution
Plug in machine
Replace cable
Replace switch
Replace soft start
Connect to correct fuse
Order service
Connect hose
Clean hose
Fit dust collection system
Replace hose
Clean filter/ Replace filter
Adjust
Clean the flap
Replace affected gaskets
Adjust/ Replace filters
Order service
896 - 004 -

Advertisement

loading

This manual is also suitable for:

S 26