Parameters/Address Space; Parameter Assignment; Reaction To Cpu Stop - Siemens SIMATIC S7-1500 Manual

Parameters/Address space

4.1

Parameter assignment

Introduction
You configure and assign the parameters of the communication module with STEP 7 (TIA
Portal V12 or later) or with STEP 7 with integration of a GSD file.
Additional information
The device manual of the communication module is supplemented by the function manual
CM PtP - Configurations for point-to-point connections
(http://support.automation.siemens.com/WW/view/en/59057093) and the TIA Portal
information system.
There you will find information on the following topics:
● Operating modes
● Receive buffer
● Data flow control
● Transmission integrity
● Data transmission - protocol specific
● Programming/configuring in STEP 7 (TIA Portal)
● Module-specific instructions
● Diagnostics
4.2

Reaction to CPU STOP

Ongoing transmissions are aborted when the higher-level control (CPU) goes to STOP.
Frames in the receive buffer are retained. With a corresponding configuration in the
properties dialog of the communication module, you can automatically clear the receive
buffer on the communication module during CPU startup.
CM PtP RS232 BA communication module (6ES7540-1AD00-0AA0)
Manual, 01/2013, A5E03777472-01
4
17