Warnings; Set Up - Yamaha Enduro 8 Manual

Total log distance
Total log distance is
counted up to 99'999,9
NM. The first two most
significant digits "d
00" and the four low-
er digits "000.0" are
alternately displayed.
The value is per-
manently stored in
memory. In addition,
total log distance is
permanently copied
into all other displays in
the system, to provide a
backup.
Total log distance is a
global function in the net.
Dead Reckoning
Position
The D.R.-counter is
cleared with the left
button. Present posi-
tion is calculated from
heading and log
speed and displayed
as bearing and dis-
tance from origin.
D.R. position is a
local function. It may be
cleared and displayed
independently on different
displays.
Voltmeter
This function dis-
plays the battery
voltage (as mea-
sured at the display).
Alerts:
correct "SE" (see display
configuration).
nected.
Settings:
all three buttons.
2. Release SELECT
button first, then the others.
3. Adjust brightness with left or right button.
All other displays with the same group
number will follow in brightness.
4. Exit from the dimmer function with the
SELECT-button.
3
Sensor Type Alert
It is displayed
automatically, if more
than one display unit
has been configured
for the same log sen-
sor.
All displays
should be checked for
Three dashes in-
stead of the numbers
are an indication that
no display has been
configured for a log
sensor. Verify the
correct SE=.. of the
Display which has
the log sensor con-
Low Battery Alarm
The battery alarm
comes on when the
supply voltage has
dropped below 10
Volts. It disappears
after voltage has ris-
en above 11 Volts.
The display stops
working below 9 Volts.
Illumination
If you have a dim-
mer installed in the
system, it must be
used. Only without a
dimmer use the push
buttons for illumina-
tion control:
1. Press and hold