Structure And Specification 2-1 To; Structure And Parts Name - Hitachi HIDIC EH-150 Applications Manual

Chapter 2

2.1 Structure and Parts name

Name and function
No Name
1) Lock button
2) LEDs
3) Connector 1
4) Reset switch
*1
5) DIP switch
(No. 1,2 not used)
6) Termination switch ON: bus termination enabled
7) Connector 2
Note1: For setting of this switch, remove the module from the rack.
If the setting ends, cover with the protection sheet.
STRUCTURE and SPECIFICATION
1) Lock button
2) LEDs
3) Connector 1
4) Reset switch
5) DIP switch
6) Termination switch
7) Connector 2
Function
This is used when removing the module from the base unit.
After it is installed to the base unit, the fixation can be
reinforced using screws. In this case, use M4x10 mm screws.
STATUS: the state of the EH-RMP
RUN: communication running
ERR: error on communication line
RDY: device has no error
TOKEN: lit all the time
Connect to PC(configurator)
When module is abnormal, module is be reset by pushing this.
Switch No.
4 3
OFF OFF
CLEAR mode: the output data is cleared.
OFF ON
FREEZE mode: the output data is frozen.
ON OFF COPY mode: the output data is copied from the CPU.
Not use
ON ON
OFF: bus termination disabled
Connect to field bus
Chapter 2 STRUCTURE and SPECIFICATION
Model
Weight
Current
dimension (mm)
30
Supplementary explanation
(when the CPU is stopped)
2-1
EH-RMP
Approx. 130g
Approx. 600mA
95
Remarks
9pin male D-sub
Be careful, this connector
become hot.
9pin female D-sub
The screw is the terminal for
functional earth.