Cable Check, Warning Indication - Hitachi CA-HF1300-S3 Operating Instructions Manual

Cable check, Warning indication

Cable check: Optical system
CU-HD1300F-S3 automatically checks the condition of optical cable, and shows the results on both PIX
OUT screen and LED indicators on front panel at start-up. If any troubles are detected, the camera power
might be forced to shut down for safety.
Indication
PIX OUT
: CHECK CAMERA CABLE
CAMERA CABLE SHORT
CAMERA CABLE:HYBRID
LED: SHORT lights
PIX OUT
: CAMERA CABLE OPEN
CAMERA CABLE:HYBRID
LED: OPEN lights
PIX OUT
: CHECK CAMERA CABLE
CAMERA CABLE SHORT
CAMERA CABLE:SINGLE
LED: SHORT lights
PIX OUT
: CAMERA CABLE OPEN
OR CHECK CAMERA POWER
CAMERA CABLE:SINGLE
LED: OPEN lights
PIX OUT
: CCU FAN ALARM!!
PIX OUT
: CAMERA FAN ALARM!!
PIX OUT
: CCU OPT WARNING!
LED: YELLOW in CCU OPT LEVEL lights
PIX OUT
: CCU OPT ALARM !
LED: RED in CCU OPT LEVEL lights
PIX OUT
: CAMERA OPT WARNING!
LED: YELLOW in HEAD OPT LEVEL
lights
PIX OUT
: CAMERA OPT ALARM !
LED: RED in HEAD OPT LEVEL lights
LED: GL blinks
The power line may be short-circuited.
Camera power defaults to off and camera power switch is
rendered inoperative.
Cable mode is Selected the HYBRID.
Cable is not connected.
Camera power defaults to off and camera power switch is
rendered inoperative.
Cable mode is Selected the HYBRID.
The power line may be short-circuited.
Camera power defaults to off and camera power switch is
rendered inoperative.
Cable mode is Selected the SINGLE.
Cable is not connected.
Camera power defaults to off and camera power switch is
rendered inoperative.
Cable mode is Selected the SINGLE.
FAN warning of CCU
The internal fan is stopped or the rotating speed is lowered.
FAN warning of camera head or camera adaptor
The adaptor internal fan is stopped or the rotating speed is
lowered.
The optical receiver level of CCU is low.
Check a fiber cable, and clean the terminal if necessary.
The optical receiver level of CCU is very low.
Check a fiber cable, and clean the terminal if necessary.
The optical receiver level of camera head is low.
Check a fiber cable, and clean the terminal if necessary.
The optical receiver level of camera head is very low.
Check a fiber cable, and clean the terminal if necessary.
It blinks, when the synchronized signal of the format at the
time of use and a different format is inputted.
21
Content