Table of Contents
Advertisement
Front and Rear of Unit
Rear Panel
The CRW2200E drive's rear panel features the following:
DIGITAL AUDIO OUT connector
If your sound card has a SPDIF (digital audio) input connector, you can connect the
DIGITAL AUDIO OUT connector of the unit to the SPDIF connector using a digital audio
cable (sold separately).( P. 22)
ANALOG AUDIO OUT connector
Connect one end of the 4-pin audio cable to this and the other end to your computer's
sound card or built-in audio. ( P. 21)
Jumper switch
Plug a plastic shunt into this jumper switch to select the connection, either IDE master or
slave. The CRW2200E drive's factory setting is SLAVE. ( P. 17)
IDE INTERFACE CONNECTOR
Insert the connector of the IDE cable here. Make sure you align the red line of the ribbon cable
with pin 1 of the drive's connector, marked "IDE INTERFACE CONNECTOR 1." ( P. 20)
DC INPUT connector
Insert the power connector from your computer's power supply in this socket to feed power
to the drive. ( P. 23)
8
Advertisement
Table of Contents
