Initial Use; Boiling Water - Silvercrest SWKC 2400 B2 Operating Instructions Manual

Initial use

WARNING! RISK OF INJURY!
► Always and only use freshly drawn mains water in the kettle! Do not consume
any water that is not certified as potable. If you do, you are taking a risk
with your health!
Before starting the appliance up, make certain that ...
–
the appliance, plug and power cable are in a serviceable condition and ...
–
all packaging materials have been removed from the appliance.
1) Remove the lid
2) Fill the appliance with water up to the MAX mark and let it come to a full boil
once – as described in the next section.
3) After it has boiled, pour this water away.
4) Rinse the kettle out with clear water.
5) Refill the appliance with water up to the MAX mark, and then bring it to the
boil. When done, pour this water away also.
6) Rinse the kettle out with clear water.
The appliance is now ready for use.

Boiling water

RISK! ELECTRICAL SHOCK!
► Never place the electrical base
potentially fatal risk!
WARNING! RISK OF INJURY!
► Always use freshly drawn water. Do not consume any water that has already
stood in the kettle for longer than one hour. Do not reboil water that has cooled
down. Always pour old water away. Microbes could have formed in it!
NOTE
► Always ensure that the ON/OFF switch
mains plug is unplugged and the appliance is standing on the base
not, the device could heat up unintendedly as soon as the mains plug is
plugged in again.
1) Lift the kettle off of the base when filling it!
2) Remove the lid
SWKC 2400 B2
.
close to water – this would be a
.
is not pressed down when the
GB │ IE
. If
│
19 ■