Connections - Yamaha AV-S7 Owner's Manual

CONNECTIONS

Connect the provided speakers to the SPEAKERS
terminals on the rear of the SW-AVS7.
All of the speakers are identical.
The speakers connected to the FRONT R and L
terminals should be used as the right and left front
speakers.
The speakers connected to the REAR R and L
terminals should be used as the right and left rear
speakers.
Notes
● Do not connect speakers to the SW-AVS7 other than
the provided ones.
● Use the provided speaker cords for the connections.
Normally, use the short cords to connect to the front
speakers, and use the long ones to connect to the
rear speakers. The four cords are marked FRONT L,
FRONT R, REAR L and REAR R for your reference.
Label
How to Connect:
Connect the provided speaker cords between the
SPEAKERS terminals on the power
amplifier/subwoofer (SW-AVS7) and the speaker
terminals on each speaker as shown below. If the
connections are incorrect, no sound will be heard from
the speakers. Make sure that the polarity of the
speaker wires is correct with reference to the + and –
markings. If these wires are reversed, the sound will
be unnatural and lack bass.
To avoid mistakes, connect the wire with a line to the +
terminals on both the power amplifier/subwoofer (SW-
AVS7) and speaker, and connect the wire with no line
to the – terminals on both of them.
Caution
Do not let the bare speaker wires touch each other
as this could damage the SW-AVS7 and/or the
speakers.
On the SW-AVS7:
Red: positive (+)
Black: negative (–)
On the FRONT and REAR speakers (NX-AV1):
Red: positive (+)
Black: negative (–)
E-15
Lift up the tab.
Insert the bare wire.
[Remove approx.
5mm (1/4")
insulation from the
speaker wires.]
Press down the tab
and secure the
wire.
Press the tab.
Insert the bare wire.
[Remove approx.
5mm (1/4")
insulation from the
speaker wires.]
Release the tab and
secure the wire.