Yamaha AN1x Owner's Manual page 103

8. Set the velocity sensitivity of the VCA.
Press KNOB PARAMETER GROUP switch [VCA], then
press CONTROL knob 8 to display the Vel Sens
(Velocity Sensitivity) parameter in the LCD. Turn the
knob to set a value near "+15" to increase the
sensitivity.
9. Adjust the cutoff frequency and set the
velocity sensitivity of the VCF.
Press KNOB PARAMETER GROUP switch [VCF], then
press CONTROL knob 5 once to display the VCF
Cutoff parameter in the LCD. Turn the knob to set a
value near "75" to soften the sound.
Press CONTROL knob 8 once to display the Vel Sens
(Velocity Sensitivity) parameter in the LCD. Turn the
knob to set a value near "+15", to increase the
sensitivity applied to the VCF with playing strength.
Next, use CONTROL knob 5 to further adjust the VCF
Cutoff. Use knob 7 to set the FEG Depth to your liking,
and use knob 8 to further define the Vel Sens
according to your playing style.
NOTE The Velocity Sensitivity setting affects the rate of change of the FEG Depth. The
FEG Depth setting determines the range of the change.
10. Apply vibrato to the voice.
Press KNOB PARAMETER GROUP switch [VCO1] and
press CONTROL knob 8 to display the Pmod Depth
(Pitch Modulation Depth) parameter in the LCD. Turn
the knob to set a value of about "+20". This applies
the vibrato effect to the voice when you play.
Next, let's set up the vibrato to be applied by the
[MODULATION] wheel, in order to control the amount
of vibrato as you play. Change the Pmod Depth setting
back to "0".
We'll use one of the 16 sets in the Control Matrix to
assign the VCO1 Pitch Modulation Depth parameter to
the [MODULATION] wheel.
Set the [EDIT ROTARY] switch to the VOICE SCENE
SETUP menu.
• Press Set No [UP/DOWN] to display "Set 1" in the
LCD.
• Press Param [UP/DOWN] to display "VCO1
PmodDp" in the LCD.
• Press Source [UP/DOWN] to display "A.MW" in the
LCD.
You can also assign a Control Change number to the Source, by which to control
NOTE
the Parameter. In this case the Control Change number must match the setting in
the UTILITY SETUP menu's Control Device and Control Number.
You can control the vibrato of the VCO1 by moving the
[MODULATION] wheel. To further define the range of
vibrato control, press Depth [UP/DOWN] to set a
value of "Dp+20".
We'll use another Control Matrix set to assign the
VCO2 Pitch Modulation Depth parameter also to the
[MODULATION] wheel.
• Press Set No [UP/DOWN] to display "Set 2" in the
LCD. "Param Off" will also be indicated.
• Press Param [UP/DOWN] to display "VCO2
PmodDp" in the LCD.
• Press Source [UP/DOWN] to display "A.MW" in the
LCD.
You can control the vibrato of the VCO2 by moving the
[MODULATION] wheel. To further define the range of
vibrato control, press Depth [UP/DOWN] to set a
value of "Dp+20".
NOTE Try setting different Control Matrix Depth values to the VCO1 and VCO2 to hear
the effect produced.
There are many other parameters you may
want to adjust to get just the right sound you
want. When you're finished with the editing
process, perform a Voice Store operation to
store your creation. For information, see page
98.
103