Environmental Regulations And Disposal Information; Conformity Notes - Silvercrest SHSD 2600 A1 Operating Instructions And Safety Instructions

SilverCrest SHSD 2600 A1
The water dispensed is too cold or too hot.

The hot water dispenser saves the last water temperature and volume setting. Use the water
temperature button (5) to set the correct temperature before dispensing water.
Display "E7"
If a beep sounds, all the displays flash and error E7 appears, the water reservoir (9) is empty or is
not properly seated on the heater unit (14). Fill the water reservoir (9) with at least 0.5 l of water.
Also make sure that the water reservoir (9) is properly seated on the heater unit (14). See the
sections on "Fitting the water reservoir" on page 34 and "Filling the water reservoir" on page 35.

10. Environmental regulations and disposal information

Devices marked with one of these symbols are subject to the European Directive
2012/19/EU. All electrical and electronic devices must be disposed of separately
from household waste at official disposal centres. Avoid damage to the
environment and risks to your personal health by disposing of the device properly.
For further information about proper disposal, contact your local government,
disposal bodies or the shop where you bought the device.
Dispose of all packaging in an environmentally friendly manner. Cardboard
packaging can be taken to paper recycling centres or public collection points for
recycling. Any film or plastic contained in the packaging should be taken to your
public collection points for disposal.

11. Conformity notes

This appliance has been approved for compliance with the basic and other relevant
requirements of the Low-voltage Directive 2014/35/EU, the EMC Directive
2014/30/EU, the ErP Directive 2009/125/EC and the RoHS Directive
2011/65/EU.
The complete EU Declaration of Conformity is available for download from this link:
www.targa.de/downloads/conformity/288632.pdf
42 - English