System Configuration (Optional); Configuration; Firmware Update - Bosch EV2000 Series Installation And Operation Manual

6. Swipe the authorized RFID card to stop.
7. Return the plug to the holder.
7.0 System Configuration
(Optional)
WARNING! Only configure the charger when
the charger is not in charging mode to avoid
interruption of an ongoing charging session.
1. Contact service provider to login online configuration
tool.
2. When the configuration is done, copy the
parameter file (DeltaDCWallboxConfig) to the root of a
USB flash drive. (The drive format should be FAT/FAT32,
< 32GB).
Bosch Automotive Service Solutions Inc.
EV2000 Series Wallbox Charger Installation and Operation Manual| 9 | en
3. Insert the USB flash disk into the USB port on the
bottom (labeled USB). The configuration will be
uploaded to the DC Wallbox.
4. Remove the USB flash drive when the configuration
is complete.
7.1 3G Configuration
For models equipped with the 3G modem, insert a
valid 3G (WCDMA) SIM card as detailed in previous
steps (page 21) to start 3G connection. Consult with
local operator to activate data service on the SIM
card beforehand. Disable PIN check on the SIM card
before inserting the card into the modem. Request APN
information from the operator and make sure APN is
configured correctly via the configuration tool.

7.2 Firmware Update

Firmware updates can be made via the USB port on the
bottom of the cabinet.
1. Obtain a USB flash drive. The drive format should
be FAT/FAT32, < 32GB.
2. Insert the USB flash disk into the USB port on the
bottom of the unit (labeled USB).
579604 | REV. C | June 2020