Yamaha CC-70W Owner's Manual page 39

RECORDING COMPACT DISCS
Receiver
CD Player
9
1
1
6
6
A
TIME
3
DISC SKIP
PRESET
7 DOWN
PLAY
4
POWER
Display information during programming
Selected disc
Side of the tape
TRACK
A
1 2 3 4 5 6 7 8 9
Selected track number
TRACK
A
1 2 3 4 5 6 7 8 9
Programmed track numbers illuminate and
unprogrammed ones flash.
1
1
TUNER DIRECT
2 3 4 5
5
2 3 4 5
7 8
7 8 9 0
B C D E
+
PROG TAPE EDIT I0
SEARCH STOP PLAY/PAUSE
SKIP
RANDOM REPEAT
CD
A/B/C/D/E
9
UP TUNER
STOP PLAY
TAPE
REC/PAUSE DECK PHONO/AUX
A/B 1
SLEEP DISPLAY VOLUME
+
-
Next playback order
10 11 12
Total remaining time on
the side of the tape
REMAIN
10 11 12
To record programmed tracks from one or
more discs
1
Press the CD input select button and load a disc (or discs)
on the disc table.
2
Follow steps 3–6 on page 35.
3
Press the PROGRAM button.
* "PROG" and "P-01" illuminate on the display, and all
track numbers on the selected disc begin flashing.
4
If necessary, select a desired disc by pressing the DISC
SKIP button.
5
Use the track number input buttons to select the desired
track number.
6
Repeat steps 4 and 5 to set more programs for the side A
of the tape. You can select the same track again.
* Pressing the TIME button displays the total remaining
time on the side of the tape for about 1 second, and
then it is replaced by the display of the next playback
order.
* If "ERR" appears on the display, the track number just
selected cannot be programmed because there is not
enough time remaining on the side A of the tape.
However, at this time, if any other track number is
flashing continuously on the display, you can program
it instead of the unprogrammable one.
7
After you finish the programming for the side A, press the
TAPE button.
* "Pu" appears on the display, then you can begin
programming for side B.
8
Repeat steps 4 and 5 to set more programs for the side B
of the tape. You can select the same track again.
* If "ERR" appears on the display, the track number just
selected cannot be programmed because there is not
enough time remaining on the side B of the tape.
However, at this time, if any other track number is
flashing continuously on the display, you can program
it instead of the unprogrammable one.
9
Press the EDIT button. ("EDIT" appears on the display.)
The recording is automatically started.
P ROG
* The unit searches a peak level on each track to adjust
the recording level properly. The search is carried out
before recording each track. (While searching, "LEVEL"
flashes on the display, and recording is paused.)
Notes on tape-editing
•
To check, cancel or correct program data, refer to page
19.
•
The maximum number of tracks that can be programmed
is 20.
•
This function can be used to program up to track number
20. If the disc has more than 20 tracks, track number 20
PRO G
and thereafter will not be programmed.
37