Yamaha CC-75 Owner's Manual page 43

RECORDING COMPACT DISCS
Receiver
1
CD Player
TIME
9
1 2
1 2
6 7
6 7
A B
TIME
TIME PROG
REPEAT RANDOM
3
MODE DISC SKIP
PLAY
7
DECK
A/B REC/PAUSE
4
EFFECT LEVEL SP/PHONES MODE
Display information during programming
Side of
Selected
the tape
disc
PROGRAM
1 2 3 4 5
A 11 12
Selected track
number
REMAIN
PROGRAM
1 2 3 4 5
A 11 12
Programmed track numbers light up
and unprogrammed ones flash.
1
CD
3 4 5
3 4 5
5
8
8 9 0
C D E
TAPE EDIT
+10
STOP PLAY/PAUSE OPEN/CLOSE 1
TUNER
STOP PLAY
TAPE
9
INPUT
DSS
1
Next playback order
6 7 8 9 10
Total remaining time on
the side of the tape
6 7 8 9 10
To record programmed tracks from one or
more discs
1
Select the CD position with the INPUT SELECTOR
control, watching the display, and load a disc (or discs) on
the disc table.
2
Follow steps 3–6 on page 33.
3
Press the PROG button.
* "PROGRAM" and "P-01" light up on the display, and all
track numbers on the selected disc begin flashing.
4
If necessary, select a desired disc by pressing the DISC
SKIP button.
5
Select the desired track number by pressing the track
number input buttons.
6
Repeat steps 4 and 5 to program more selections for the
side A of the tape. You can select the same track again.
* Pressing the TIME button displays the total remaining
time on the side of the tape for about 1 second, and
then it is replaced by the display of the next playback
order.
* If "ERR" appears on the display, the track number just
selected cannot be programmed because there is not
enough time remaining on the side A of the tape.
However, at this time, if any other track number is
flashing continuously on the display, you can program
it instead of the unprogrammable one.
7
After you finish the programming for the side A, press the
TAPE button.
* "Pu" appears on the display, then you can begin
programming for side B.
8
Repeat steps 4 and 5 to program selections for the side B
of the tape. You can select the same track again.
* If "ERR" appears on the display, the track number just
selected cannot be programmed because there is not
enough time remaining on the side B of the tape.
However, at this time, if any other track number is
flashing continuously on the display, you can program
it instead of the unprogrammable one.
9
Press the EDIT button. ("EDIT" appears on the display.)
The recording automatically starts.
Notes on tape-editing
•
If programs are made selecting tracks from more than one
disc, during recording, the PLAYXCHANGE button on the
CD player is disabled.
•
To check, cancel or correct program data, refer to page
16.
•
The maximum number of tracks that can be programmed
is 20.
•
This function can be used to program up to track number
20. If the disc has more than 20 tracks, track number 20
and thereafter will not be programmed.
E-35