Advertisement
3.
Attach the plug-to-jack adapter
to the straight SMA fitting of the
cable.
Figure 4: Attach the straight
SMA fitting
Figure 4:
Figure 5:
5.
Cut the ground cable to length. Strip ⅜ inch of insulation from
the free end.
IMPORTANT NOTE: The ground cable is attached to the ground
post located near the enclosure's door. Allow enough length for a
service loop of approximately 1 inch from the surge protector to
the ground post.
6.
Remove the crimp ring terminal from the surge protector. (See
number 1 in the following photo).
Figure 6: Crimp ring terminal
1
7.
Crimp the surge protector terminal ring to the ground cable.
8.
Re-attach the crimped terminal with ground cable to the surge
protector.
9.
Attach the cable to the surge protector (see below).
Figure 7: Attach the cable
10. Remove the split washer and hex nut from the surge protector.
6 | WI-FI ANTENNA KIT | 2106123MNAA
4.
Attach the surge protector
to the plug-to-jack adapter.
Figure 5: Attach the surge
protector
Advertisement
