Introduction; Before Applying Pow Er; Safety Precautions - Kenwood DV-502 Instruction Manual

Introduction

2

Before applying pow er

Units are designed for operation as follow s.
U.S.A. and Canada ....................................................... AC 120V only
Australia ....................................................................... AC 240 V only
For the United Kingdom
Factory fitted moulded mains plug
1. The mains plug contains a fuse. For replacement, use
only a 3-Amp ASTA-approved (BS 1362) fuse.
2. The fuse cover must be refitted w hen replacing the
fuse in the moulded plug.
3. Do not cut off the mains plug from this equipment. If
the plug fitted is not suitable for the pow er points in
your home or the cable is too short to reach.
A pow er point, then obtain an appropriate safety
approved extension lead or adapter, or consult your
dealer. If nonetheless the mains plug is cut off,
remove the fuse and dispose of the plug immediately,
to avoid a possible shock hazard by inadvertent.
Connection to the mains supply.
IM PORTANT :
The w ires in the mains lead are coloured in accordance
w ith the follow ing code:
Blue : Neutral
Brow n : Live
Do not connect those leads to the earth terminal of a
three-pin plug.

Safety precautions

WA RN IN G :TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
R I S K O F E L E C T R I C S H O C K
Downloaded from: http://www.usersmanualguide.com/
APPLIANCE TO RAIN OR M OISTURE.
CAUTION
D O N O T O P E N
THE LIGHTNING FLASH WITH ARROWHEAD SYM BOL, WITHIN AN EQUILATERAL TRI-
ANGLE, IS INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED "DAN-
GEROUS VOLTAGE" WITHIN THE PRODUCT'S ENCLOSURE THAT M AY BE OF SUFFICIENT
M AGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAM ATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT
THE USER TO THE PRESENCE OF IM PORTANT OPERATING AND M AINTENANCE (SER-
VICING) INSTRUCTIONS IN THE LITERATURE ACCOM PANYING THE APPLIANCE.
Caution : Read this page carefully to ensure safe operation.
Europe and U.K. ............................................................ AC 230V only
* Other countries .................... AC 110-120 / 220-240 V sw itchable
Caution : Read this page carefully to ensure safe operation.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REM OVE
COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SER-
VICING TO QUALIFIED SERVICE PERSONNEL.
The marking of products using lasers
The marking is located on the rear panel and says that
the component uses laser beams that have been clas-
sified as Class 1. It means that the unit is utilizing laser
beams that are of a w eaker class. There is no danger of
hazardous radiation outside the unit.
DV-502/DVF-3050 (EN/K,P,T,M ,Y)
(Except for some areas)
CLASS 1
LASER PRODUCT