Unpacking Instructions - Fujitsu DSL Modem Installation Manual

To benefit from the high-speed transmission rate of ADSL over your
existing telephone wire, your phone line and your computer must be
separated. Each DSL line must be wired through a special filter
called a splitter. While both the DSL Modem and the telephone share
a telephone line to the customer premises, the signals are separated
at the splitter, providing an isolated path to the individual wiring,
jacks, and other telecommunications hardware. This splitter is
installed by the telephone service provider.
With the use of a DSL Modem, splitter, and your existing telephone
line, you can use the telephone and download data onto your
computer at the same time. The DSL Modem splitter is completely
passive, providing "lifeline" or continuous, telephone service even if
the power fails. The DSL Modem encodes the data sent from your PC
to a corresponding DSL Modem, located at your local telephone
company.

1.2 Unpacking Instructions

Before unpacking, make a preliminary inspection of the shipping
box. Any evidence of damage should be noted and reported
immediately to the customer support center.
Note: The customer support information can be found in the product
information packet provided by your phone company.
It is recommended that you unpack the equipment on a clean, flat
surface.
1. Place the shipping box upright. Cut the sealing tape and then
open the flaps.
2. Take out the items in the box. Search the box for any additional
small items that may be present.
3. Inspect the product for damage and verify that all parts are
included.
4. Report any damage or missing parts to the customer support
center. Keep the shipping boxes and packing materials for
reuse.
2