Built-In Components - Siemens SINAMICS S120 Instruction For Installation In Cabinets For Marine Drive Applications

3.4

Built-in components

For the installation of the supplementary system components sufficiently dimensioned
top-hat rails or mounting plates / mounting rails have to be provided.
Supplementary system components, where the installation on top-hat rails is possible
have to be mounted on top-hat rails 15x35 and to be fixed on both sides by clamps (by
means of end clamps, for instance type TM31, SMC10 and VSM10.
If a supplementary system component is mounted on a mounting plate or mounting
rail, the tightening torques for screws as listed in chapter 3.3 have to be observed.
Instruction for installation of the liquid-cooled chassis of Sinamics S120 power units into cabinets for marine drive applications,
12/2016, 4BS0808-003
Mechanical design
11