Transporting Lithium Batteries - AEG ACS18B30 Original Instructions Manual

Complete saw
Chain brake
Spare parts
Chain
Bar
Exploded view
If needed, an exploded view of the tool can be ordered. Please
state the machine type printed as well as the six-digit No. on the
label and order the drawing at your local service agents or directly
at: Techtronic Industries GmbH, Max-Eyth-Straße 10, 71364
Winnenden, Germany.
BATTERIES
Battery packs which have not been used for some time should be
recharged before use.
Temperatures in excess of 50°C (122°F) reduce the performance
of the battery pack. Avoid extended exposure to heat or sunshine
(risk of overheating).
The contacts of chargers and battery packs must be kept clean.
For an optimum life-time, the battery packs have to be fully charged,
after used.
To obtain the longest possible battery life remove the battery pack
from the charger once it is fully charged.
For battery pack storage longer than 30 days:
Store the battery pack where the temperature is below 27°C and
away from moisture.
Store the battery packs in a 30% - 50% charged condition.
Every six months of storage, charge the pack as normal.

TRANSPORTING LITHIUM BATTERIES

Lithium-ion batteries are subject to the Dangerous Goods
Legislation requirements.
Transportation of those batteries has to be done in accordance with
local, national and international provisions and regulations.
■ The user can transport the batteries by road without further
requirements.
■ Commercial transport of Lithium-Ion batteries by third parties is
subject to Dangerous Goods regulations. Transport preparation
and transport are exclusively to be carried out by appropriately
trained persons and the process has to be accompanied by
corresponding experts.
When transporting batteries:
■ Ensure that battery contact terminals are protected and
insulated to prevent short circuit.
■ Ensure that battery pack is secured against movement within
packaging.
■ Do not transport batteries that are cracked or leak.
Check with forwarding company for further advice
SYMBOLS
Safety alert
Read and understand all instructions before
operating the product, follow all warnings and
safety instructions.
After each use
Every 5 hours of operation
Oregon
90PX045X
XXXX
Wear eye, ear and head protection.
Wear non-slip safety footwear when using the
product.
Wear non-slip, heavy duty gloves.
Wear eye and face protection.
Wear upper body protection.
Wear leg protection.
Beware of chain saw kickback and avoid contact
with bar tip.
Do not expose to rain or damp condition.
Moving direction of the chain.
(Marked under the chain cover)
Hold and operate the saw properly with both
hands.
Do not operate the saw using only one hand.
Remove the battery pack before starting any
work on the product.
Do not burn used battery packs.
Never charge a damaged battery pack. Replace
with a new one.
Set the chain brake to the RUN position.
Rotate to adjust chain tension
+ = Tighten the chain
- = Loosen the chain
Set the chain brake to the BRAKE position.
No-load chain speed is 10 m/s
V : 10 m/s
0
Maximum guide bar length is 300 mm
L max: 300 mm
The guaranteed sound power level is 99 dB.
31
31
ENGLISH