Table of Contents
Advertisement
32/56
Operation
Information on the
hydraulic fluid
Bleeding the hydraulic
system
Performing the leak test
Bosch Rexroth AG, DB(W)...5X/...E, RE25802-B/09.19
• The released operating media and limitations of operation for your safety valve are
contained in "Data sheet 25802".
• Bosch Rexroth offers the suitable seal designs for the hydraulic fluid used.
Observe the operating instructions of the system into which the valve is installed.
Switch the valve several times under operating pressure before placing it into full
1.
operation. This will expel any remaining air from the valve. Mechanical damage
due to inadmissibly high acceleration of the hydraulic fluid and the control spool
is thus avoided and the valve's life cycle is increased.
You can also achieve the switching movement of the valve spool necessary for the
bleeding procedure by manually actuating the manual override. For further
information, see chapter 9.4 "Operating the optional manual override at the
directional valve".
Check whether during operation hydraulic fluid leaks at the safety valve and at the
connections.
9 Operation
Incorrect area of application!
The approval according to Pressure Equipment Directive and thus the safe pressure
limiting function are no longer applicable if the safety valve is used incorrectly or
outside its area of application.
Do not use the safety valve as high-response valve!
f
Possible unloading via the directional valve must not be applied for safety-
f
relevant functions!
If unloading is required for safety-relevant functions, an additional unloading
f
valve must be installed.
For information on the operation, please refer to the operating instructions for
the hydraulic system into which the safety valve is installed.
If errors occur, refer to chapter 14 "Troubleshooting".
WARNING
Advertisement
Table of Contents
