Bosch TCE 260 Operation Manual page 17

3. Position the tool head
$
Step down the pedal 7-1 to move the tool head to
the original work position.
Note: If you do not change the rim, the tool head will
automatically back to the correct working position.
4. Mount the bottom bead
$
Position the bottom bead at the bottom end of
the head of the tool head, while at the top end of
the tail of the tool head.
$
Use your hand to slightly press the tire to lead the
tire into the groove of the rim.
$
Rotate the turntable clockwise to mount bottom
bead.
Robert Bosch GmbH
Operation | TCE 260 | 17
5. Mount the upper bead
$
Position the upper bead at the bottom end of the
head of the tool head, while at the top end of the
tail of the tool head.
$
Press the tire edge and lead the tire edge into
steel hook slot.
The tire edge can not slide out of the head of
the tool head.
Note: When you mount/ demount the tire, tire
rotates clockwise. If the tire is jamming during the pro-
cess, please stop working and counterclockwise rotate
the tire to remove the jamming.
Do not place your hand on the tire. When the
hexangular shaft comes back to its work position, the
hand between the rim and the tool head may be crus-
hed. Remove the objects may cause the danger to the
operators such as bracelet and loose cloth etc. To avoid
the accident, when the turntable rotates, you should
keep your hand and the other part of your body away
from the tool head as far as possible.
en
|
1 987 AT7 374 2015-09-02