Table of Contents
Advertisement
42
en | Installing the Roof Parapet and Pipe Mounts
No.
Connector
P101 115/230 VAC or
24 VAC Power In
P107 24 VAC Power to
Dome Plug
10.3
Attach Cover Door to Power Supply Box
1.
Figure 10.4: Align Cover Door Hinge to Power Box
1
2
3
4
2.
3.
4.
2020-07 | 1.0 |
Pin 1
Pin 2
Line
NC
Dome
Dome
24 VAC
24 VAC
Compress the bottom hinge pin by pushing the pin lever down and then rotate it behind
the Hinge Pin Stop. The power box Cover Door provides a Hinge Pin Stop to hold the
bottom hinge open while attaching the door.
LINE NC NEUT
GND T XD R XD
C+ C-
GND T XD R XD
Power Supply Box
Cover Door
Align Top Hinge
Align Bottom Hinge
Open the top hinge by pushing its pin lever outward and holding it open.
Note: Both Hinge Pins must be fully compressed to open (unlock) the female hinges of
the Cover Door before proceeding to the next step.
While holding the top hinge pin open, position the Cover Door to the Power Supply Box
and align its hinges.
When the hinges are aligned, release the top hinge pin to engage its mating hinge on the
power box. Then release the bottom hinge pin from the Hinge Pin Stop to complete
attaching the Cover Door to the Power Supply Box.
Installation Manual (pendant)
Pin 3
Pin 4
Neutral
Earth Ground
Heater
(24 VAC)
o
90
C+ C-
5
6
7
AUTODOME inteox 7000i - 2MP (pendant)
Pin 5
Pin 6
Heater
(24 VAC)
Hold Hinge Pin Open
Open Position
Hinge Pin Stop
Bosch Security Systems
Advertisement
Table of Contents
