Advertisement
7. Remove the #6-32 screws from their bag and screw the wall mount onto the wall box, as shown in
3.
8. Connect any required cables to the rear of the access point.
9. Align the mounting slots on the back of your 205H access point with the corresponding posts on the wall
mount as shown in
Figure 4 Securing 205H access point to Wall Mount
10. Push the access point against the holes and then downward until the posts engage the slots at the top of
the mounting holes.
11. (Optional) Using the second T8H Torx security screw provided, insert into the hole on the upper-right
side of the mount and tighten to lock the 205H access point into the mount.
12. Position the prongs on the back of the front cover inside the slots on the front mount housing, as shown
in
Figure
Figure 5 Fitting Front Cover onto Wall Mount
205H-MNT2 Wall Mount Kit
Figure
4.
5.
| Installation Guide
Figure
3
Advertisement
