Advertisement
13. Slide the cover into the tracks toward the access point until the left side of the cover is level with the
side of the mount. Refer to
position (right).
Figure 6 Plastic Side Cover Sliding into Wall Mount (Rear View)
14. (Optional) Once the front cover is securely attached to the mount, insert one of the T8H Torx Security
Screw into the hole located at the left side of the cover and tighten until secure.
15. (Optional) If not using PoE, connect the AC-DC power adapter (sold separately, part number
) to the DC power socket located on the right of the 205H access point.
SER
0511763-03
Figure
6, demonstrating the cover sliding from open position (left) to locked
205H-MNT2 Wall Mount Kit | Installation Guide
AP-CBL-
Advertisement
