Right Side - Toshiba PA3314U User Manual

User's manual
Power switch
NOTE: Pressing the power switch has no effect if a computer is not
connected to the Port Replicator.
Slide adjuster
Center mark

Right side

Refer to Figure 2-1 for the location of items on the Port Replicator's right side.
Eject switch
Eject LED
Eject lever
2-2
Press the power switch to turn the docked computer's
power on and off.
If necessary, slide the adjuster forward or backward so that
it will be flush against the computer.
The computer is connected with port replicater according
to a center mark.
You can use the eject switch to enable hot undocking.
Press the eject switch to begin the computer's disconnect
sequence. When the eject LED goes out it is safe to
disconnect the computer.
Glows green during normal operation. When the eject
switch is pressed, the eject LED goes out when the
computer completes its disconnect sequence.
This lever pops out for easy disconnection of the com-
puter from the Port Replicator. Refer to Chapter 3 for
disconnect procedures.