Table of Contents
Advertisement
Bosch Sensortec"|
Application Board 3.0 User Guide
BTN-CTRL
BTN-T1
BTN-T2
LED-CTRL
LED-RED
LED-BLUE
LED-GREEN
PWR-CTRL
VDD-SEL
VDD-EN
VDDIO-EN
BAT-MEAS
VBAT-MON-EN
VBAT-MON
5 Shuttle Board 3.0
Dimensions
The following figure describes the typical dimensions of the Shuttle Board 3.0 for standard shuttles.
Figure 5 Standard Shuttle Board 3.0 dimensions
The following figure describes the typical dimensions of the Shuttle Board 3.0 for multi-sensor shuttles.
Modifications reserved | Data subject to change without notice
GPIO_33
P1.09
GPIO_7
P0.25
GPIO_45
P0.07
GPIO_46
P0.12
GPIO_32
P0.11
GPIO_44
P0.27
GPIO_16
P0.03
GPIO_17
P0.28
GPIO_18
P0.02
GPIO_20
P0.31
Active low. When activated, connected
to ground through a 360ohm resistor
Active low. When activated, connected
to ground through a 360ohm resistor
Active low. Connected to 2.8V through
a 100ohm resistor
Active low. Connected to 2.8V through
a 33ohm resistor
Active low. Connected to 2.8V through
a 10ohm resistor
When low, 1.8V is routed to Vdd and
2.8V when high
Routes selected Vdd voltage to the
Shuttle's Vdd pin when high and routes
Ground when low
Routes 1.8V to the Shuttle's VddIO pin
when high and routes Ground when low
Active low. When activated, connects
the Li-ion anode to the voltage divider
Output of the voltage divider. 3V is read
as 1.125V and 4.2V as 1.575V. R1 is
300kohm and R2 is 180kohm
Document number: BST-DHW-AN008-00
11 | 22
Advertisement
Table of Contents
