Table of Contents
Advertisement
Bosch Sensortec"|
Application Board 3.0 User Guide
8 Maintenance
Warning: Damage to materials can cause risk of fire!
Liquid entering the device can cause short circuits and damage the device. This could cause fire, data loss
and incorrect measurements.
9 Further Product Related Information
Please find all product related documents and user guides on our website:
10 Regulatory and legal information about the Application Board 3.0
European Union notices
European Union notices Radio Equipment Directive
Hereby, Bosch Sensortec GmbH declares that the radio equipment type "Application Board 3.0" is in
compliance with Directive 2014/53/EU (Radio Equipment Directive). The full text of the EU declaration of
conformity is available at the Bosch Sensortec internet address.
Conformity).
RoHS
The Application Board 3.0 meets the requirements of the Directive 2011/65/EU on the restriction of the use of
certain hazardous substances in electrical and electronic equipment (RoHS Directive).
The certification for the European Union only applies to Application Board 3.0 devices with the CE printed on the housing.
The user shall verify before using the Application Board 3.0 in the European Union.
USA: FCC notices
FCC has issued an EQUIPMENT AUTHORIZATION to Bosch Sensortec GmbH for Application Board 3.0 according to
FCC rule parts 15 C with the FCC ID: 2AO4I-APP30.
Note: Changes or modifications not expressly approved by Bosch Sensortec GmbH could void the FCC certificate and
therefore user's authority to operate the equipment."
The radiated output power of the device is far below the FCC radio frequency exposure limits. Nevertheless, the device
shall be used in such a manner that the potential for human contact during normal operation is minimized.
The device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) The device may not cause harmful interferences, and
2) This device must accept any interferences received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
Modifications reserved | Data subject to change without notice
https://www.bosch-sensortec.com/
Document number: BST-DHW-AN008-00
18 | 22
Advertisement
Table of Contents
