Dismantling And Assembling The Robotic Lawnmower - Husqvarna Automower 420 Technical Manual

5.2 Dismantling and assembling
the robotic lawnmower
IMPORTANT INFORMATION
Clean any grass and dirt from the
robotic lawnmower before you begin
disassembling.
5.2.1 Dismantling the body
The body is fitted to the chassis using 4 quick-
mounted, snap-on brackets. The charging cable
fastened to the body's charging strip must be dis-
connected to be able to remove the body entirely
from the chassis.
1. Set the main switch in 0 position.
2. Clean the area around the grommet for
the charging cable found at the very front
under the mower.
3. Pull out the rubber grommet on the
charging cable and carefully loosen the
connector.
4. Loosen the body from the chassis by
lifting the body one corner at a time while
holding the chassis in place.
5.2.2 Dismantling the chassis
The chassis consists of upper and lower sections.
These are screwed together with 14 screws.
1. Dismantle the body, see 5.2.1 Dismantling
the body on page 59.
2. Loosen all 14 screws (Torx 20).
3. Remove the warranty seal at the point of
separation between the chassis halves on
the right-hand side.
4. Carefully lift the back edge of the upper
section of the chassis.
5. REPAIR INSTRUCTIONS
English - 59