Servo Board-2; Servo Board-2 - Sony XAV-701BT Service Manual

2-3.

SERVO BOARD-2

Note 1: Before disconnecting the OP fl exible board, solder the short-land.
Note 4: When assembling the SERVO board, remove the solder
of short-land after connecting the OP flexible board.
OK
NG
SERVO board
2 Solder the short-land.
Note 3: When solder the short-land, be sure to refer to
"NOTE FOR FLEXIBLE BOARD OF THE
OPTICAL PICK-UP" of the servicing notes
(See page 2).
Note 9: Check that OP flexible board is not
caught in a lever (lock B).
lever (lock B)
OK
Note 8: Arrange OP flexible board
under the chassis at this part.
OP flexible board
SERVO board
Note 7: When installing the OP flexible board,
Do not touch this portion.
Note 5: Check that solder
does not remain
in solder points.
Solder remains.
OP flexible board
3 OP flexible board
(CN2)
A
5 claw
NG lever (lock B)
adhesive (ST-854GH) tape
4 two toothed lock screws
(M1.7 2.5)
A
Note 2: Adhesive (ST-854GH) tape cannot
1 adhesive (ST-854GH)
tape
Note 6: When installing the flexible board, please install them correctly.
There is a possibility that this machine damages when not
correctly installing it.
OK
Insert is straight
Insert is shallow
to the interior.
flexible borad flexible borad
connector
XAV-701BT/741
6 SERVO board
re-used. Please replace to brand-new
part ones adhesive (ST-854GH) tape
is removed.
NG NG
Insert is incline
flexible borad
connector connector
5