Initial Use; Cutting Hair - Silvercrest SHBD 600 A1 Operating Instructions And Safety Instructions

SilverCrest SHBD 600 A1
In order to fit one of the six comb attachments (12), push them carefully onto the blade block
(1) of the hair & beard trimmer until both prongs of the comb attachment (12) on the right and
left lock into the recesses on the hair & beard trimmer. To remove a comb attachment (12),
remove the prongs on the left and right from the recesses on the hair & beard trimmer and take
off the comb attachment (12).
Please note: The comb attachments (12) need to be fitted so that the teeth of the comb
attachments (12) are pointing in the direction in which the hair & beard trimmer moves.

7. Initial use

7.1. Cutting hair

The hair & beard trimmer can be used either in battery mode or with a connected mains
adapter (6).
DANGER! Take care when shaving areas of the body with thinner skin (for
example, armpits or pubic area). There is a risk of injury.
The hair being cut must be dry.

Firstly, familiarise yourself with the hair & beard trimmer and try to hold it so that the
on/off button (3) can be easily pressed. Please make sure that it rests securely in your
hand.

Give your hair a good comb through.

If necessary, use a comb attachment (12) to achieve the desired cutting length.
If you are not sure which comb attachment (12) you should use, start with the
largest (28--- - 30 mm) first and then change to a smaller comb attachment (12) if you
need to.
12 - English