Pressure Reference [33]; Identify The Device [34]; Reset [35] - Siemens SITRANS P Operating Instructions Manual

Note
To have the process value for "Level", "Volume", "Mass flow", "Volume flow" or "Customized
characteristic curve" shown as the "Start view", first set the associated characteristic curve
using the "Application" (Page 110) parameter.
9.2.31

Pressure reference [33]

Used to adapt the display of the pressure unit to your application.
Setting range:
Factory setting:
See also
Pressure units [01] (Page 106)
9.2.32

Identify the device [34]

Enables or disables the device identification via HART.
When device identification is enabled, the device signals its identification data via HART.
With device identification enabled, the device responds to a request with the HART command
"Find device".
Setting range:
Factory setting:
9.2.33

Reset [35]

Used to reset the following settings:
Setting range:
SITRANS P320/P420 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E44852162-AC
NONE
GAUGE
ABS
NONE
ON Device identification enabled
OFF Device identification disabled
OFF
Restore ordered configuration
Reset to sensor calibration
Reset DAC trim to the factory setting
Factory reset
9.2 Parameter assignment over device with display
Not specified
Gauge pressure
Absolute pressure
Parameter assignment
CUST
SENSR
DAC
FACT
143