Bodysar; Gps - Huawei Atool User Manual

HUAWEI Module Atool User Guide
This command can be executed only in the LTE/UMTS/TD-SCDMA module.

5.10 bodysar

Command
syntax:
Command
function:
Parameter
description:
Example:

5.11 gps

Command
syntax:
Command
function:
Parameter
description:
Issue 02 (2015-01-31)
atool bodysar
Tests and displays the bodysar status of the module as well as the
bodysar settings of each communications standard supported by
the module.
No parameter.
atool gps [-t CN0 target]
Tests whether the GPS antenna is properly installed based on the
highest carrier-to-noise ratio (CNR), namely, CN0.
-t: This parameter sets the CNR threshold, which must be a positive
integer. If this parameter is set, the Atool compares the obtained
CNR with the specified CNR. If the obtained CNR is lower than the
specified CNR, an error is reported.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Console Commands and Parameters
17