Silvercrest LHL 2000 B1 Operating Instructions Manual page 12

Overheating protection
The appliance is fitted with a overheating protector. Should the appliance become too hot
internally, the heating element switches itself off automatically. Once the appliance has cooled
itself down, the heating element switches back on automatically.
WARNING
As a general rule, overheating has a reason! It can mean a risk of fire!
► Check that the appliance can sufficiently disburse the heat generated:
Is the appliance covered or is it too close to a wall or other obstacle? Are the grilles
on the front or back clear? Is the ventilator blocked?
If possible, eliminate the problem or contact the Service Hotline (see Chapter Service).
►
► Even if you cannot find a cause, but the overheating protection triggers a second
time, you must return the appliance to Customer Services for inspection or repair.
Tilt cut-out
This Fan Heater is fitted with a safety switch
off automatically. The Fan Heater first switches itself on again when it is in an upright position
and the safety switch
Cleaning
WARNING
Observe the following safety information to avoid risks and property damage:
► Only clean the appliance when it is switched off and cold.
IMPORTANT
Possible damage to the appliance.
Penetrating moisture can lead to the appliance becoming damaged.
► When you are cleaning the appliance ensure that no moisture can get inside, so as
to avoid irreparable damage to it.
Clean the housing exclusively with a soft damp cloth and a mild dishwashing liquid.
Remove dust deposits on the protective screen with a vacuum cleaner.
Storage
Disconnect the mains power plug if you do not intend to use the appliance for an extended
period of time.
Store the appliance in a dry environment.
LHL 2000 B1
3 is actuated.
3 . Should the Fan Heater tip over, it switches itself
GB │ IE │ NI │ 9 ■