Table of Contents
Advertisement
Changing the Password
To set or change the controller password, move the cursor bar to
"Change Password", then press [Enter].
If a password has previously been set, the controller will ask for the old
password first. If the password has not yet been set, the controller will
directly ask for the new password. The password can not be replaced
unless a correct old password is provided.
Key-in the old password, then press [Enter]. If the password is
incorrect, it will not allow you to change the password. Instead, it will
display the message "Password incorrect!", then go back to the
previous menu.
If the password is correct, or there is no preset password, it will ask for
the new password.
Setting a New Password
Enter the desired password in the column, then press [Enter]. The next
dialog box will display "Re-Enter Password". Enter the password again
and press [Enter].
Chapter 8 RS-232C Terminal Interface
181
Advertisement
Table of Contents
