GE Multilin 489 Instruction Manual page 82

Note
4–20
Courtesy of NationalSwitchgear.com
The Phase Overcurrent setpoint window will open with a corresponding status indicator on
the lower left of the EnerVista 489 Setup window.
If the status indicator is red, verify that the serial cable is properly
connected to the relay, and that the relay has been properly configured
for communications (steps described earlier).
Setpoints can now be edited, printed, or changed according to user specifications. Other
setpoint and commands windows can be displayed and edited in a similar manner. Actual
values windows are also available for display. These windows can be locked, arranged,
and resized at will.
Refer to the EnerVista 489 Setup help file for additional information about using the
software.
CHAPTER 4: INTERFACES
489 GENERATOR MANAGEMENT RELAY – INSTRUCTION MANUAL