ABB axial A100-M Series Original Assembly Instructions page 13

Assembly Instructions / A170-M, A175-M
4 Installing the turbocharger / ​
Removing auxiliary screws
Fig. 5: Removing auxiliary screw
Remove shipping screws (90334 / 90335) on the left and right side of the foot and place
u
in the toolbox.
The turbocharger is delivered with a pre-installed sliding block (68003). The shipping screws
secure the sliding block in the preset position. In operation, the foot can slip due to thermal
expansion.
Tighten clamping nuts as described in the following sections.
u
Connect all gas, air and oil pipes.
u
If present: Re-fit the insulation segments.
u
If present: Connect cable to speed sensor.
u
Compressor-end (CE) foot
Fig. 6: Compressor-end foot
© Copyright 2020 ABB. All rights reserved. HZTL455311P0007_EN Rev.A July 2020